Data Acquisition & Analysis
Sensors, channels, math channels, overlays, histograms, frequency analysis, metrics and simulation.
Starting at L1 · Foundation
What a DAQ system is: sensors, logger, ECU and sampling rates
A data acquisition system turns physical quantities into time-stamped numbers. Understanding the chain sensor → conditioning → ADC → logger, and choosing sensible sampling rates, decides whether the data can answer your questions at all.
Analysis software essentials: plots, overlays, XY, histograms, filtering, run notes
Most analysis is comparison. Know when to plot against time or distance, how to read XY plots and histograms, how filtering changes what you see, and how to keep run notes so data stays tied to a setup.
Comparing laps: delta time, segment times and track mapping
Find where time is gained or lost before asking why. Delta-time channels, segment times, theoretical best laps and accurate distance alignment are the backbone of every debrief.
Checking vital signs and building alarm channels
The first job of the data system is to keep the car running. Check vitals before performance, learn their normal patterns, and build alarm logic that warns the driver without crying wolf.
The beginner’s logging kit and sensor plausibility checks
Learn what the six basic signals and damper pots look like on a good lap, and how to verify sensors with physics – pit-lane steady-state checks, sign conventions and cross-channel consistency.
Starting at L2 · Practitioner
Math channels: a practical toolbox
Math channels turn raw sensor data into engineering quantities: corrected speed, understeer angle, roll gradient, slip ratio, total gear ratio, combined g and delta time. Learn the core set, their assumptions and where they break.
Measurement fundamentals: ADC resolution, sensor specs and uncertainty
Every logged number is an estimate. Know how ADC resolution and sampling limit what you can see, how to read a sensor data sheet, and how to put an honest uncertainty on a result – including whether a setup change really made a difference.
Sensor technology: temperature, pressure, displacement, acceleration, strain, speed and GPS
Choose sensors by asking what, what range, what environment, what accuracy and what budget. Know the working principle and failure modes of the sensors on your car so you can trust – or distrust – their data.
Frequency analysis basics: FFT, PSD and the sampling theorem
Suspension behaviour is easier to judge in the frequency domain: an FFT or PSD of damper, ride-height and acceleration signals reveals body and wheel modes, and transfer functions quantify platform control and tyre-load fluctuation.
Data analysis with metrics, KPIs and run charts
Compress thousands of samples into one number per lap. Well-designed metrics in run charts reveal trends across stints, days and seasons – and let you relate any parameter to lap time quickly.
Lap time simulation: steady-state, quasi-steady-state, transient, and correlation with data
Simulation lets you test without the track, but only a model correlated against logged data is worth trusting. Learn the simulation levels, the vehicle–tyre–track model structure, how to correlate, and how to use sims before, during and after an event.
Track data and track characterisation
Data tells you what kind of circuit you are at: speeds, gear usage, brake energy, full-throttle share, corner direction balance, g-g quadrant usage and bumpiness. Use these numbers to choose the baseline setup and tyre pressures before turning a wheel.
Practise: scenarios
- Misano: front tyres fading after six laps L2
- Imola: the car launches off the Variante Alta kerb L3
- Hockenheim: choosing start pressures for a no-stop race L3
- Suzuka Esses: "the rear is loose" — but is it? L3
- Sebring Turn 17: the front grounds on the bumps L3
- Monza qualifying: hot pressures too high L1
- LMP3 at Spa: the floor hits the ground at the bottom of Eau Rouge L1
- LMP2 at Sebring: heave spring choice and the damper histogram L3
- LMDh at Sebring: rear instability on entry from brake-by-wire blending L3
- F4 at Imola: "massive oversteer" that the data does not show L1