Springs, Anti-roll Bars & Heave
Wheel rates, ride frequency, roll stiffness distribution, third/heave elements, packers and bump rubbers.
Starting at L1 · Foundation
Wheel rate, tyre rate & ride rate (springs in series)
The spring on the damper is not the stiffness the tyre sees. Motion ratio turns spring rate into wheel rate, and the tyre acts as a second spring in series, giving the ride rate that actually sets body frequency.
Ride frequency and how to choose it
Ride frequency normalises stiffness by sprung mass so cars of different weight can be compared. Choosing it is a trade between mechanical grip over bumps and aero platform control, with the front/rear ratio shaping pitch behaviour.
Anti-roll bars and roll stiffness distribution
Anti-roll bars add roll stiffness without adding heave stiffness. The front/rear split of total roll stiffness sets most of the lateral load transfer distribution (LLTD) and is the primary mechanical balance tool.
Corner weights, cross weight and setting up on scales
Corner weights describe how the static load is shared between the four tyres. The diagonal (cross weight) is adjusted with spring platforms and determines whether the car behaves the same in left- and right-hand corners.
Starting at L2 · Practitioner
Roll gradient & roll ratio as setup tools
Measure suspension roll from damper pots, regress it against lateral g, and you get front and rear roll gradients and their ratio – objective, lap-by-lap metrics of roll stiffness and its distribution that also flag broken bars and deflating tyres.
Heave / third springs: decoupling heave from roll
A third (heave) element acts only when both wheels of an axle move together. It lets aero cars hold ride height under downforce with high heave stiffness while roll stiffness and single-wheel compliance are tuned separately.
Bump stops, packers and progressive rates
Bump stops (bump rubbers) and packers turn a linear suspension into a progressive one. Used deliberately they control ride height at speed – the aero platform – while keeping softer springs for low-speed grip; used carelessly they cause sudden balance shifts.
Pitch gradient and the aero platform
Pitch gradient (pitch angle per g of longitudinal acceleration) characterises how the platform moves under braking and traction. On aero cars it drives aero balance changes on entry and exit and is shaped by heave stiffness, bump stops and anti-geometry.
Practise: scenarios
- Coppa Shell at Mugello: "it just won't turn in" L1
- Imola: the car launches off the Variante Alta kerb L3
- Spa, rain qualifying: setting up a Cup car without TC L2
- Paul Ricard: power oversteer out of the slow corners L2
- Barcelona: understeer only in the fast corners L2
- Sebring Turn 17: the front grounds on the bumps L3
- Spa: front-wheel-drive understeer in Pouhon L1
- LMP3 at Spa: the floor hits the ground at the bottom of Eau Rouge L1
- LMP3 at Barcelona: wheelspin and snap on slow-corner exits L2
- LMP2 at Sebring: heave spring choice and the damper histogram L3