Driver Analysis
Braking technique, throttle application, steering smoothness, lines, consistency and coaching with data.
Starting at L1 · Foundation
Analysing braking technique: brake point, peak pressure, build rate, trail braking and release
Braking is where drivers differ most. Quantify brake point, time to peak, peak pressure, modulation and release with a handful of math channels, and connect them to deceleration and corner entry.
Throttle application: full-throttle %, throttle acceptance, pickup and hesitation
The throttle is the driver’s primary interface. Histograms, full-throttle time, throttle acceptance, throttle speed and coasting metrics reveal whether a driver is too careful, too aggressive, or fighting the car.
The cornering sequence and driving lines: minimum speed, apex placement, V vs U corners
Every corner is a sequence: braking, turn-in to apex, apex to exit. Use the corner-radius and curvature channels to locate the apex, judge the line, and decide whether a corner should be driven V-shaped (rotate and drive out) or U-shaped (carry speed).
Starting at L2 · Practitioner
Steering smoothness and corrections: steering rate and error metrics
Steering traces show both driver technique and car balance. Steering-speed and steering-error metrics quantify smoothness and corrections – but only mean something once you know whether the car is balanced and the driver is at the limit.
Consistency analysis and lap-time variation
Race pace is won by consistency. Quantify it with lap-time statistics, sector reports and per-corner metrics, separate it from fuel and tyre effects, and recognise the data signatures of fatigue.
Comparing two drivers and coaching with data
Comparison is the heart of driver development. Use a structured process – speed and delta first, then inputs, then line – and deliver it in a way the driver can absorb, acknowledging that car balance and driver technique are intertwined.
Driver activities that indicate vehicle balance
Drivers react to a handling problem before they can describe it. Steering, throttle and lateral g patterns reveal understeer and oversteer by corner phase – and distinguish a car problem from a driver-induced one.
Putting the driver in the simulation: sim racing and driver-in-the-loop
Offline lap simulations assume a driver at the limit everywhere. Driver-in-the-loop simulators add the human – their perception, confidence and technique – and all the data-analysis methods transfer one-to-one to virtual laps.
Practise: scenarios
- Coppa Shell at Mugello: "it just won't turn in" L1
- Monza qualifying: spin at the start of the first flying lap L1
- Zandvoort: front-right locking into Tarzan (no ABS) L1
- Suzuka Esses: "the rear is loose" — but is it? L3
- Bathurst 12 Hour: one extra lap per stint L3
- Laguna Seca FP1: "no grip anywhere" L1
- British GT, Silverstone: Am vs Pro on entry understeer L2
- LMP3 at Barcelona: wheelspin and snap on slow-corner exits L2
- LMP2 at Spa: hitting a fuel target with lift-and-coast L2
- F4 at Imola: "massive oversteer" that the data does not show L1
Practise: data exercises
- Read the lap: a GT3 baseline at Valmont L1
- Late on the throttle out of the hairpin L1
- Over-slowing into the first corner L1
- Coasting: zero throttle, zero brake L1
- Front lock-up into the hotel hairpin L2
- Rear wheelspin out of the hairpin L2
- Mid-sweeper lift and an exit snap: two balance problems L3
- Steering activity: a nervous driver or a nervous car? L3
- Ranking the losses: one lap, four problems L4
- "The car understeers everywhere" – driver or car? L4