Engineering toolbox
Trackside calculators
Motion ratio & wheel rateRide frequencyRoll stiffness & roll gradientLoad transfer & corner loadsAckermann steeringAero balanceBrake balanceGearing & gear chartDamping ratioCornering speed with downforceFuel & stint planner
Damping ratio
Compute critical damping and damping ratio for the body (sprung) and wheel-hop (unsprung) modes of a corner.
Critical damping and damping ratio
Units: K in N/m, m in kg, c in N·s/m. Two-mode decoupled approximation of the quarter-car. With one linear damper the ratio of the two is ζhop/ζbody = √(KR ms / ((Kw+Kt) mu)), with KR = KwKt/(Kw+Kt) the ride rate.
Damper
Corner
Results
Damper slope
8000 N·s/m
Damping at wheel
4500 N·s/m
Body critical damping
9733 N·s/m
body fn 2.92 Hz
Wheel-hop critical damping
9198 N·s/m
hop fn 16.3 Hz
Body ζ (sprung mode)
0.46
soft race range (0.4–0.55) – bumpy tracks, mechanical grip
Wheel-hop ζ (unsprung mode)
0.49
typical (0.2–0.7)
With a single linear slope the same damper acts on both modes, and for typical race corners ζhop/ζbody ≈ 1.0–1.2: the small unsprung mass is offset by the large Kw+Kt, so wheel-hop damping comes out roughly equal to body damping. Real dampers are digressive: the low-speed slope (body motions, roughly below 25–50 mm/s) sets body ζ, while the lower high-speed slope above the knee (kerbs, bumps, wheel hop) sets hop ζ – enter it above to see its effect.