Tyres
Slip angle, slip ratio, load sensitivity, camber thrust, temperature and pressure windows – the only contact the car has with the track.
Starting at L1 · Foundation
Slip angle and cornering stiffness
A tyre only makes lateral force by running at a slip angle. The slope of the force-vs-slip curve (cornering stiffness) sets the car’s linear response, and the peak sets its grip.
Slip ratio and longitudinal force
Braking and traction force need the tyre to rotate slightly slower or faster than free rolling. Peak force on dry slicks comes at a slip ratio of roughly 6–12%, and wheel-speed data shows you where the driver and the electronics operate.
Combined slip and the friction ellipse
A tyre has one friction budget shared between lateral and longitudinal force. The friction ellipse describes the trade, and its non-linearity explains trail braking, exit traction limits and many balance complaints.
Load sensitivity: why load transfer costs grip
Tyre friction coefficient falls as vertical load rises, so an axle with unequal wheel loads makes less total force than the same axle with equal loads. This is the root of LLTD balance tuning and of why downforce gives less than proportional grip.
Camber and camber thrust
Negative static camber is run so the loaded outside tyre has an even contact pressure at the limit, not mainly for camber thrust. The cost is braking/traction patch, inner-shoulder heat and tyre-supplier limits.
Operating windows: temperature, hot vs cold pressure, TPMS
A race tyre only delivers its grip inside a temperature and pressure window. You set cold pressures, but the tyre works at hot pressures, so the engineer’s job is predicting the build-up and verifying it with TPMS.
Reading tyre temperatures: probes, IR sensors and math channels
Inner/middle/outer temperatures tell you about camber, pressure and which tyre is working hardest. On-car IR adds corner-by-corner detail and lets you build objective channels: spread, pressure index, workload share and time-in-window.
Practise: scenarios
- Monza qualifying: spin at the start of the first flying lap L1
- Misano: front tyres fading after six laps L2
- Spa, rain qualifying: setting up a Cup car without TC L2
- Hockenheim: choosing start pressures for a no-stop race L3
- Spa 24h: +20 kg BoP ballast — where does the time go? L4
- Monza qualifying: hot pressures too high L1
- Laguna Seca FP1: "no grip anywhere" L1
- Hypercar at Le Mans at night: compound choice without tyre warmers L2
- Hypercar at Spa: the balance changes when the front axle switches on L4
- GTP at Long Beach: locking the fronts over the T1 bumps L4