Weight Transfer & Balance
Lateral and longitudinal load transfer, LLTD, roll centres, the understeer gradient and the g-g diagram.
Starting at L1 · Foundation
Lateral load transfer and its three components
Total lateral load transfer is fixed by mass, CG height, track width and lateral g. Suspension only decides how it is split between axles and through which path: unsprung, geometric (roll centre) or elastic (springs/bars).
Longitudinal load transfer, pitch and anti-geometry
Braking moves load to the front and acceleration to the rear by m·a_x·h/L. Springs and anti-dive/anti-squat geometry do not change that total; they decide how much pitch it causes, which matters for aero platform, braking stability and traction.
The g-g diagram and using the friction envelope
Plotting lateral against longitudinal acceleration shows the car’s performance envelope and how much of it the driver uses. It is speed dependent (aero), asymmetric (power, drag) and best analysed in speed bands and with gated grip statistics.
Starting at L2 · Practitioner
LLTD, the "magic number" and mechanical balance
The front share of total lateral load transfer (LLTD) is the main mechanical balance parameter. A commonly quoted starting point is front LLTD about 5 points above static front weight, but the right number depends on tyres, drivetrain, aero and driver.
Understeer gradient and steady-state cornering (bicycle model)
The linear bicycle model defines understeer gradient, neutral steer, characteristic and critical speed. In data it becomes the understeer-angle channel, a powerful balance statistic, provided you remember it is only strictly valid in the linear range.
Banking, grade and vertical curvature effects
Banking, uphill/downhill grade and crests/compressions change both the normal load on the tyres and what the accelerometers read. Correct for them before comparing grip, balance or load-transfer data between corners or tracks.
Total wheel loads: aero, transfer and estimation from data
Each tyre’s vertical load is the sum of static weight, lateral and longitudinal transfer, aero load, banking/grade and bump content. You can estimate it from accelerations and setup data, or measure it via damper potentiometers or load cells, as long as you know what each method misses.