Aerodynamics
Downforce, drag, aero balance, ride-height sensitivity, platform control, coast-down testing.
Starting at L1 · Foundation
Downforce, drag & air density
Downforce and drag both scale with dynamic pressure ½ρV². Engineers work with the products C_L·A and C_D·A, and must correct for air density (temperature, pressure, altitude, humidity) before comparing sessions.
Aero balance & centre of pressure
Aero balance is the front share of total downforce (equivalently, where the centre of pressure sits along the wheelbase). Its relation to the static weight distribution decides how the car's balance changes from slow to fast corners.
Starting at L2 · Practitioner
Ride-height sensitivity, rake & aero maps
On any car with an underbody, downforce, drag and balance depend strongly on dynamic front and rear ride heights. Aero maps capture this; the engineer's job is to place the car's dynamic platform in the right region of the map.
Platform control & ground effect: diffuser, stall, porpoising, plank
Underbody downforce rises as the car gets closer to the ground — until the flow stalls. Controlling the dynamic platform (heave, pitch, roll) to stay near the peak without crossing the cliff is the core of modern aero setup, and the source of porpoising.
Measuring aero on track: coast-down, constant-velocity & logged-data estimates
Drag from coast-downs, downforce and balance from constant-speed runs with suspension loads, and both from normal laps with the right corrections. Includes a fully worked GT3 straight-line test.
Aero efficiency & trim choice: low drag vs high downforce
L/D describes efficiency, but the right trim is decided by the track's exchange rate between downforce and drag. Monza and Le Mans reward low drag; Monaco and Hungary reward downforce. Marginal efficiency of each change matters more than the car's overall L/D.
Wings, Gurneys & dive planes: typical adjustment sensitivities
What a wing click, a Gurney or a dive plane actually does to total downforce, balance and drag on GT3 and formula cars — and how to verify it on track despite driver and weather noise.
Aero in traffic (dirty air, slipstream) & yaw sensitivity
Following another car reduces dynamic pressure and disturbs the flow: less drag on the straight but lost (mostly front) downforce in fast corners. Yaw from body slip and crosswind changes downforce and balance too. Both should shape race setup and strategy.
Practise: scenarios
- Spa, rain qualifying: setting up a Cup car without TC L2
- Barcelona: understeer only in the fast corners L2
- Spa 24h: +20 kg BoP ballast — where does the time go? L4
- Daytona: on the limiter in the draft L4
- Sebring Turn 17: the front grounds on the bumps L3
- LMP3 at Spa: the floor hits the ground at the bottom of Eau Rouge L1
- LMP2 at Le Mans: top speed vs the Porsche Curves L2
- Hypercar at Spa: the balance changes when the front axle switches on L4
- LMDh at Spa: understeer in slow corners, oversteer in fast ones L3
- F4 at the Red Bull Ring: front wing flap for the fast corners L1