Learn / Race Engineering & Strategy / Running a test or practice session: run plans, change discipline and tyre allocation
L2 · Practitioner

Running a test or practice session: run plans, change discipline and tyre allocation

Track time is the scarcest resource. A run plan with clear objectives, disciplined one-at-a-time changes, controlled tyre and fuel states, and a baseline check turns a session into knowledge instead of noise.

Running a test or practice session: run plans, change discipline and tyre allocation: L1 Foundation explanation

Every session needs an objective. Typical race-weekend structure:

  • FP1: installation and systems check, track learning, baseline balance, first reading of tyre pressures and temperatures.
  • FP2/FP3: setup direction, race simulation (long run on race fuel), qualifying preparation.
  • Qualifying: execute the plan; no experiments.

The run plan lists for each run: purpose, setup change, tyre set (new/used, laps), fuel load, number of laps, what the driver should evaluate, and which data to check afterwards. Share it with mechanics (changes to prepare), the driver (what to feel), and the tyre engineer (pressures, sets).

Change discipline:

  • One change at a time when you want to learn – otherwise you can't attribute the result.
  • Make changes big enough to be felt and measured (one ARB step, not a quarter). Small changes vanish in lap-time noise (σ 0.2–0.4 s).
  • Return to baseline at the end to check track evolution (an A–B–A sequence).
  • Write down everything: setup, tyre set, pressures cold/hot, fuel, track temperature, driver comment, lap times.

Key formulas

Minimum resolvable lap-time difference (95 %)
Δtmin≈2 σ2n\Delta t_{min} \approx 2\,\sigma\sqrt{\frac{2}{n}}
σ\sigma
lap-time scatter (s), known from long-run history; if estimated from the same few laps replace 2 by t_{2n-2}
n
clean laps per configuration
Laps per configuration to detect an effect Δ (two-sided α = 5 %, power 80 %)
n≈2 (zα/2+zβ)2 σ2Δ2≈15.7 σ2Δ2n \approx \frac{2\,(z_{\alpha/2} + z_{\beta})^2\,\sigma^2}{\Delta^2} \approx \frac{15.7\,\sigma^2}{\Delta^2}
Δ\Delta
true effect to detect
zα/2z_{\alpha/2}
1.96
zβz_{\beta}
0.84

Trackside takeaways

  • Write a run plan with objective, change, tyres, fuel, laps and driver focus for every run.

  • One change at a time to learn; packages only when the interaction is known and accepted.

  • Changes must be large enough to exceed lap-time noise; use corner metrics for small effects.

  • Control tyre age and fuel; repeat the baseline (A–B–A) to catch track evolution.

  • Plan tyre allocation backwards from qualifying and race needs.

On your car

BoP fixes many parameters (ride height minimums, wing ranges); sessions focus on balance (ARBs, dampers, pressures) and race-pace long runs with heavy fuel.

Check yourself

Question 1 / 4L1 · Foundation

Why is changing the rear anti-roll bar, the rear wing and the tyre pressures in the same stop a poor way to learn?

Further reading
  • Segers – Analysis Techniques for Racecar Data Acquisition — §2.3 Keeping Notes with Data Files; §2.8 Getting Organized
  • Segers – Analysis Techniques for Racecar Data Acquisition — §15.5 How to Integrate Lap Time Simulation in Daily Data · virtual test day, test-plan screening
  • Milliken & Milliken – Race Car Vehicle Dynamics — Ch. 11 Testing and Development